Aastra 6730I - Configurable Home;Idle Screen Modes

Operational Features
5-31 41-001343-02 REV05 – 07.2014
Idle Screen Image Requirements for the 6867i:
• 240x320 pixels
• 24-bit color depth.
• Both .png and .jpg files are supported
• There should be no frame around the image
• Avoid using images with light-colored elements
Configuring Background Image on Idle Screen
Use the following procedures to configure the background image on the idle screen
Configurable Home/Idle Screen Modes
The 6867i IP phone contains two Home/Idle screen layout options. The default primary screen mode provides users with
a larger date and time and displays the Screen Name (“sip screen name”) parameter beside the line number in the top
status bar.
The secondary screen mode displays both the Screen Name and Screen Name 2 parameters. They are displayed above
the smaller, repositioned date and time.
Administrators can switch the home/idle screen to the preferred layout by defining the “idle screen mode” parameter in
the configuration files or by navigating to the Display options menu on the phone.
Configuration Files
For specific parameters you can set in the configuration files, see Appendix A, the section, “Background Image on Idle Screen” on pageA-55.
Note:
Applicable to the 6867i IP Phone only.
Note:
Screen Name 2 (“sip screen name 2”) is not displayed on the 6867i IP phone’s screen when the primary screen mode is
configured for use.
Primary Home/Idle Screen Mode
Secondary Home/Idle Screen Mode