Aastra 6730I - Page 341

Operational Features
41-001343-02 REV05 – 07.2014 5-100
Configuring Priority Alerting using the Aastra Web UI
Use the following procedure to configure Priority Alerting using the Aastra Web UI.
Call Waiting Tones
Call Waiting is a feature that tells you if a new caller is trying to contact you when you are already on the phone. A discreet
tone alerts you to the new caller, so you can answer your second incoming call by putting your first caller on hold.
The IP phones use the following Bellcore-specified call waiting tones.
Aastra Web UI
1. Click on Basic Settings->Preferences.
2. In the "Priority Alerting Settings" section, enable the "Enable Priority Alerting" field by checking the check box. (Disable this field by
unchecking the box).
For Sylantro Servers:
3. Select a ring tone pattern for each of the following fields:
• Group
• External
• Internal
• Emergency
• Priority
• Auto call distribution
• Community 1
• Community 2
• Community 3
• Community 4
4. Click Save Settings to save your changes.
Bellcore Call-Waiting Tone Pattern ID Pattern Minimum Duration (ms) Nominal Duration (ms) Maximum Duration (ms)
CallWaitingTone 1 1 Tone On 270 300 330
Bellcore-dr2 CallWaitingTone2 2 Tone On
Tone Off
90
90
100
100
110
110