Aastra 6730I - Page 706

Operational, Basic, and Advanced Parameters
A-100 41-001343-02 REV05 – 07.2014
Parameter –
sip amr codec mode set
Configuration Files
aastra.cfg, <model>.cfg <mac>.cfg
Description Specifies the list of mode sets supported and also the preferred mode to use if multiple
modes are supported by both sides.
Format Integer
Default Value 0
Range 0-7
0 (4.75 kbps)
1 (5.15 kbps)
2 (5.90 kbps)
3 (6.70 kbps)
4 (7.40 kbps)
5 (7.95 kbps)
6 (10.2 kbps)
7 (12.2 kbps)
Example sip amr codec mode set: 2,1,0,3,4
Parameter –
sip amr wb codec mode set
Configuration Files
aastra.cfg, <model>.cfg <mac>.cfg
Description Specifies the list of mode sets supported and also the preferred mode to use if multiple
modes are supported by both sides.
Format Integer
Default Value 0
Range 0-8
0 (6.60 kbps)
1 (8.85 kbps)
2 (12.65 kbps)
3 (14.25 kbps)
4 (15.85 kbps)
5 (18.25 kbps)
6 (19.85 kbps)
7 (23.05 kbps)
8 (23.85 kbps)
Example sip amr wb codec mode set: 2,1,0
Parameter –
sip out-of-band dtmf
Configuration Files
aastra.cfg, <model>.cfg, <mac>.cfg
Description Enables or disables out-of-band DTMF. Enabling this parameter forces the IP phone to
use out-of-band DTMF according to RFC2833.
Note:
See “Out-of-Band DTMF and DTMF Method on page 4-79” for DTMF behavior informa-
tion when this parameter is used in conjunction with the “sip dtmf method” parameter.
Format Boolean
Default Value 1
Range 0 - Disable
1 - Enable
Example sip out-of-band dtmf: 0