Model 6757i IP Phone Installation Guide 19
Other Phone Features
• To adjust the headset volume, press the volume button while
the headset is activated (activate the headset by pressing ; ensure
headset audio mode is set). The headset will remain at this volume until
it is adjusted again.
• To adjust the speaker volume, press the volume button while
the speaker is activated (activate the speaker by pressing ; ensure
handsfree speakerphone audio mode is set). The speaker will remain at
this volume until it is adjusted again.
Status Lights (LEDs)
The speaker LED, beside the key, and the Message Waiting
Indicator (MWI) LED, on the top right of your phone, provide visual
indications of your phone’s status.
Speaker LED
Message Waiting Indicator (MWI)
Call Timer
• When you make or answer a call, the Timer shows the elapsed time of
the call.
Line/Call Appearance Keys
The 6757i has 4 hard/line call appearance keys each with a corresponding
status light. Additional line call appearances may also be set up on your
phone as softkeys.
These line/call appearance buttons and lights represent physical lines or
calls for your extension. By pressing a line call appearance button, you
connect to the line or a call it represents. The line call appearance light
indicates the status of that line or call.
When the phone is taken off-hook, the phone will automatically select a
line for you.
Speaker LED Status Description
ON solid Indicates a call is on Handsfree (speakerphone)
Slow Flash Indicates you are using the headset.
Rapid Flash
Indicates the call is muted. Press to take the
call off mute.
MWI LED Status Description
Slow Flash Indicates you have a message(s).
Rapid Flash Indicates you have an incoming call.
Even Flash Indicates one or more calls are on hold.
Line Call Appearance LED Status Description
OFF Indicates idle line or no call
activity
To Next Page
Loading...
