Model 6757i IP Phone Installation Guide 23
Model M670i and M675i Expansion Modules
5. Line up the screw holes on the connector plate with the screw holes on
the back of the phone.
6. Insert the two screws (included with your expansion module) into the
connector plate holes and secure to the IP Phone.
7. Turn over both units to sit face up on the desk with the expansion mod-
ule sitting flush against the right side of the phone.
The following example shows the M670i attached to a 6755i IP Phone.
Back of Expansion
Module
Back of Phone
RJ-45 Cable
Connector Plate
Screw Holes on
Connector Plate
Screw Holes on Phone
Expansion Module
To Next Page
Loading...
