Ascotel IntelliGate 2025/2045/2065
216 Routing elements Part 2
4.1.2 Routing Functions of the Trunk Group for Incoming
Calls
The following incoming routing functions are assigned to the trunk group:
• Restricting the number of calls incoming simultaneously per trunk group
• Routing a call to one of the following elements:
– Direct dialling plan (see page 223)
– Call distribution element (see page 226)
– Destination of the internal numbering plan (see page 276)
• Adapting the numbering plan identifier of an incoming call
Restricting the Number of Calls Incoming Simultaneously per Trunk Group
Once the set limit is reached ("Incoming connections" setting), no more calls are
routed via the trunk group. This is signalled to the caller by means of the conges-
tion tone.
After an initialization the limit is set to approx. 80% of the available B channels.
4.1.3 Trunk Group Identification Functions
The CLIP numbers of outgoing calls can be influenced by the following settings in
the trunk group configuration:
• Automatic CLIP
• Numbering plan identifier (NPI)
• Type of number (TON)
• Permanent CLIP number
For more details see "CLIP with Outgoing Calls", page 187and following.
Truncate CLIP
See "Trunk groups", page 197.
To Next Page
Loading...
