Ascotel IntelliGate 2025/2045/2065
454 Features Part 2
System configuration
Tab. 2.149: Take: Key configuration
Note:
The Take function can also be enabled for data handover from one PC
to another using the "Data handover" parameter in the subscriber con-
figuration. (See also "Taking over an active connection", page 517.).
8.2.8 Do not disturb
To ensure that subscriber B is not disturbed, all incoming calls are automatically
diverted to an alternative destination C, which has to be specified using the sys-
tem configuration.
Fig. 2.170: Do not disturb
Detailed Description
Tab. 2.150: Do not disturb
Function type Note
In AIMS or on the handset the following command
is used to prepare a configurable key to take sub-
scriber 1's call on subscriber 2:
I*87(No.SC1)*(No.SC2)#XI*88#
Take requires that the parameter "Voice handover"
is set on "yes".
Interface Operating sequence / signalling on the ter-
minal
Scope
B Once the feature has been activated, B
obtains an acknowledgement tone.
C Possible destinations:
• Subscribers: internal, PISN
1)
• Operator Console
Requirement:
C is not protected against calls (Do not disturb,
*26) or Call Forwarding Unconditional (*02).
1)
The settings authorising internetwork traffic need to be observed for PISN subscribers in the public net-
work or on a virtually connected PINX (see "Exchange-to-Exchange Connections", page 321). (If the con-
nection is not authorized, the call is not forwarded.)
BA C
haz0222aaxxb0
To Next Page
Loading...
