Ascotel IntelliGate 2025/2045/2065
Part 2 Features 535
8.5.9 Switching switch groups
Switch groups defined in the system configuration can be selected by subscriber A
using switch contacts or a procedure from the terminal. The switchover can also
be carried out automatically using time-controlled functions in the System Con-
figuration (see "Time-controlled functions", page 547)
Fig. 2.211: Switching switch groups
Detailed Description
Tab. 2.281: Switching switch groups
Tip:
The significance of the switching states can be seen from the designa-
tion labels created individually for each subscriber.
Interface Operating sequence / signalling on the terminal Scope
A • The subscriber obtains an acknowledgement
tone when switching On / Off.
• Terminals connected to the S-bus cannot dis-
play the status of switching groups 2 to 9.
• System terminals: The switching status is dis-
played by the status of the LED or the corre-
sponding symbol on the display for the func-
tion key configured accordingly.
Possible interfaces:
The switch groups are operated locally on
the system.
Subscriber
authorisation
Yes / No
Switchover
to Pos. 1, 2, 3
per switch group
Switch
group
No.
Display
status
Hardware inputs
Office: F-key
General:
*851 1 D
*851 2 N
*851 3 W
Office: F-key
General:
*85x 1 D
*85x 2 N
*85x 3 W
Office to
LED on
F-key
1
2…9
Display only if a
function key (F-key)
has been defined
(recommended).
haz0231aaenb0
To Next Page
Loading...
