EasyManua.ls Logo

Aastra Ascotel IntelliGate 2025 - 5.4 Planning; 5.4.1 Ascertaining customer requirements

Aastra Ascotel IntelliGate 2025
1014 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Ascotel IntelliGate 2025/2045/2065
624 Planning DECT systems Part 3
Fig. 3.24: Remote repeater with directional antenna
The use of repeaters is indicated particularly in cases where supply coverage con-
ditions inside buildings are difficult and only a few handsets are being used.
Note:
Most repeaters do not support voice data encryption. For this reason the
"Encryption" parameter should normally be configured to "No" in the
DECT System Configuration.
5.4 Planning
In practice a regulated procedure for planning has proved sensible and, above all,
efficient. A considerable increase in efficiency can be achieved through the con-
sistent use of the aids available.
In the following, the planning procedure is described in the form of a "checklist":
1. Ascertain customer requirements.
2. Roughly determine the locations for the radio units.
3. Measure out the DECT system in situ.
4. Install and re-measure the system.
5.4.1 Ascertaining customer requirements
Since the aim of Ascotel DECT systems is to cover all kinds of different mobility
requirements in a non-standardized environment, we need to determine and
record precisely what sort of requirements the customer has in mind. Records
haz1378aaxxa0

Table of Contents

Related product manuals