Ascotel IntelliGate 2025/2045/2065
Part 4 Cabling interfaces 771
7.4.1.3 AD2 bus configuration
Depending on the line length 1 or 2 terminals
1)
can be connected on each AD2
interface. The following requirements apply with regard to the bus length to
ensure that the maximum permissible signal delay is not exceeded:
Tab. 4.33: AD2 bus length and number of terminals
Fig. 4.52: AD2 bus
Note:
The total length of the cables from the PBX to the Office terminal must
not be less than 10 m.
1)
In this connection the Pocket Adapter (PA) and the DECT radio unit are also considered as terminals.
Number of terminals Total length AD2 bus Distance between the 1st and 2nd connection
point (excl. connection cord)
1 A: max 1200 m -
2 B: max. 700 m or. 1200 m
1)
1)
For 1200 m both terminals must belong to the new family of system terminals (Office 10 / 25 / 35 / 45)
C: max. 10 m
PBX
A
1
st
connection
point
haz0032aaenb0
PBX
B
C
2
nd
connection
point
1
st
connection
point
haz0033aaenb0
To Next Page
Loading...
