Aastra Ascotel IntelliGate 2025 - 2.3.2 Settings on the Pocket Adapter; 2.3.3 Settings on the PC

Ascotel IntelliGate 2025/2045/2065
Part 5 AIMS configuration tool 841
Fig. 5.5: Configuration example for external access
See also:
"Data services", page 353.
2.3.2 Settings on the Pocket Adapter
The following PA settings are required if an Ascotel IntelliGate is configured using
a Pocket Adapter (PA) connected in parallel with an Office terminal:
Tab. 5.2: Setting on the Pocket Adapter
The transmission parameters for configuration via PA must match the parameters
set in the PBX. 9600 is set as the standard data transfer rate in the PBX.
2.3.3 Settings on the PC
AIMS runs under all the usual Windows operating systems.
The services Dial-Up Networking and TCP / IP network protocol must be installed
for local access and dial-up access. For LAN access the TCP / IP network protocol
has to be installed.
S1 S2 S3 S4 S5 S6 S7 S8 Meaning
ON OFF PC connection (together with S3 = OFF)
ON Pocket Adapter as second terminal
ON OFF RTS / CTS (important for AIMS)
ON OFF ON 9600 (basic speed setting)
OFF ON ON 19200 (max. speed)
222 22 98
T
T2
haz0784aaenc0
Exchange
Trunk group 1 (DSS1)
-> Call distribution 1
-> Direct dialling plan 1
DD No. 98
-> Call distribution 2
Direct dialling plan 1
Call distribution 2
-> DD destinat. table 2
-> DD individual
destination -
DD destinat. table 2
B trasparente
-> 898