Aastra Ascotel IntelliGate 2025 - 5 Configuration Steps; 5.1 System initialization; 5.1.1 Hardware-induced initialization; 5.1.2 Software-induced initialization

Ascotel IntelliGate 2025/2045/2065
Part 5 Configuration Steps 853
5 Configuration Steps
The configuration steps are based on the information determined during the plan-
ning and, where applicable, the installation.
5.1 System initialization
Before work can begin, the system has to be brought into a defined state. This
involves setting or deleting all the parameter values to their initialization value and
carrying out a self-test.
This initialization can be achieved in the following ways:
• With the HEX rotary switch on the mainboard
•With AIMS
5.1.1 Hardware-induced initialization
1. Set the HEX rotary switch on the mainboard to "1".
2. Switch the system off and back on again. The system is restarted.
3. When a flashing "1" appears on the display, turn the HEX rotary switch to
"F".
4. When an "F" appears, turn the HEX rotary switch to "0"; the PBX resets the
customer data (Flash EPROM).
5.1.2 Software-induced initialization
1. Carry out an initialization in the AIMS Configuration Manager or in the Fault
and Maintenance Manager under "Online – Reset PBX". If the sales channel
is also to be modified, create a new PBX in the AIMS Shell and select a sales
channel. Then under "Tools – Set/Change Sales Channel" carry out an initial-
ization using the corresponding initialization values.
Note:
Carrying out an initialization requires authorization level 3 or 4 (for ini-
tialization use the "3ascotel" password for the Installer or "4ascotel" for
the Support / Service Centre, or turn the HEX rotary switch on the main-
board to position "5").