Aastra Ascotel IntelliGate 2025 - 5.4.2 Logging a handset onto the system

Ascotel IntelliGate 2025/2045/2065
860 Configuration Steps Part 5
5.4.2 Logging a handset onto the system
Tab. 5.11: Procedure for logging a handset on to the PBX
Handsets defined in the PBX as Ascotel DECT subscribers but not yet logged on
are identified as follows:
• With an * in the numbering plan
• With "DECT not logged on" in the subscriber configuration.
A GAP handset subscriber must also identify himself on the Ascotel DECT system
with an access code. The access code must be entered in the PBX and in the GAP
handset prior to the logon procedure.
Procedure Input in AIMS Input on handset
– not logged on any-
where
Input on handset
– already logged on else-
where
1. Prepare handset for
logon.
(ABCD flashing on the
display).
Switch handset off.
Prepare handset as per
Operating Instructions up
to the step with
the display
"Home" / "GAP"
2. Prepare PBX for
logon.
• Select the subscriber
number in the DECT
system configuration
• Select "Log
Ascotel DECT sub-
scriber on"; the logon
procedure is started
on the PBX side.
3. Log handset on. Switch handset on.
Logon is carried out
automatically.
Press Foxkey under
"New";
the handset is
checked for authorization
and then assigned its sub-
scriber number and any
group membership (user
group).
4. Wait for confirma-
tion.
"OK" confirmation on
the display.
"OK" confirmation on the
display.