Ascotel IntelliGate 2025/2045/2065
Part 5 Configuration Steps 861
5.4.3 Logging a handset off the system
In the System Configuration under "Mobile: DECT” in the system configuration.
"Select "Log Ascotel DECT subscriber off"; log-off procedure is initiated.
Tip:
The handset identification is deleted if the handset is located within the
coverage range of a radio unit; if not, it must be deleted manually on the
handset (see Handset Operating Instructions). The Ascotel DECT sub-
scriber number and the data is saved in the PBX (identified with an * in
the numbering plan).
5.4.4 Logging a visitor handset on and off
If a Ascotel DECTsubscriber is configured as a visitor, he can be logged on via
AIMS (Attendant authorization level) or the System Assistant on the Office 45 for
the duration of his visit.
The visitor’s destination should be ascertained at the same time so that he can be
logged on to the ideal PINX.
In addition to the procedure described above for logging a handset on and off,
you also need to specify the duration of the visit in the subscriber configuration.
It is advisable to enter the visitor's name.
One hour before the visiting time is due to expire, the system sends the following
message to an internal subscriber: "DECT SC No. will be logged off in one hour".
This subscriber is configurable. (See Tab. 5.9)
When the visiting time expires, the handset is automatically logged off from the
system.
5.5 Reading initialization values
The following configuration can be set to check the initialization values:
1. In offline mode on the AIMS Shell create and open a new system of the type
2045.
2. Open Configuration Manager.
To Next Page
Loading...
