Ascotel IntelliGate 2025/2045/2065
872 Function check Part 6
3.3.2 Outgoing Traffic
Sets up the maximum possible number of connections for a trunk group and tests
the network interfaces trunk group by trunk group.
Note:
Take note of the following:
– All non-connected network interfaces must be barred.
– Analogue network interfaces reserved for incoming traffic can be
tested only by calling the corresponding lines.
– Check the connection quality between analogue network and
analogue / digital subscribers in both directions and optimize the
attenuation setting of the analogue network interfaces (see "Attenu-
ation on analogue network interfaces", page 604).
3.3.3 Incoming traffic
Sampling test of the configured call distribution by calling main and DDI numbers.
Checkpoints:
• Are the calls distributed in accordance with the System Configuration?
• Are the destinations depending on the switch position of a switch group cor-
rectly routed?
• Is the ERC (External Remote Control) working?
3.4 Testing terminals
System terminals must be installed in their definitive locations. A second person is
required to carry out the tests.
3.4.1 Office 45
Checkpoint:
• Full-duplex handsfree operation (with expansion card DSP-02 only)
Additional checkpoint for Office 45pro
• Power supply unit for illuminated display
To Next Page
Loading...
