Ascotel IntelliGate 2025/2045/2065
Part 8 Generation Change 959
2 Generation Change
Ever since it was first introduced in 1988, the system has undergone a number of
further developments. The PBX hardware, among other things, was entirely rede-
signed at the time of the generational change to I5. It is therefore no longer pos-
sible to upgrade or expand an older system to I5 or I6.
New software is required for the generation change from I5 to I6. On the 2065
system the RAM and Flash cards also need to be replaced. All the existing expan-
sion cards and terminals can still be used on the I6 system.
Note:
A 2065 system can only be upgraded from I5 to I6 on site as manual
interventions are required on the system.
2.1 System Upgrade 2025 / 2045
Upgrading a 2025 / 2045 system from I5.X to I6.X requires only new system soft-
ware. The system upgrade can be carried out on site or remotely:
1. Initiate the upload process as described in the paragraph "Initiating an upload
process", page 894. Select "Start Now" as the activation time.
Note: To upload the system software you first need to change the password
in AIMS 5 once.
2. Once the upload is completed, the PBX resets and is then ready to operate
again with the new I6 system software and the usual system configuration.
AIMS 6 is required in order to update the I6 system. Once AIMS 6 has been
installed and started, the switch in PBX generation from I5 to I6 has to be carried
out on the corresponding system. Note: If the PBX generation is incorrect, AIMS 6
cannot access the PBX after the software upgrade and generates the correspond-
ing error message.
2.2 System Upgrade 2065
Upgrading a 2065 system to I6 requires AIMS 6, a new system software and addi-
tional RAM and Flash memory. An "Update-Set" consisting of a RAM card and a
Flash card is provided for this purpose. The Flash card also contains an I6 system
software, which simplifies the upgrade:
To Next Page
Loading...
