Ascotel IntelliGate 2025/2045/2065
Part 8 PC Dial commands 983
7 PC Dial commands
Tab. 8.21: Activating the PC Dial application
Tab. 8.22: Dial command
If the number contains macro characters, use the "/" character to separate it from
"ATD". The "@" character is the same as "/A".
Tab. 8.23: Examples of dial command
Tab. 8.24: Signalling an incoming call
Tab. 8.25: Other commands
Tab. 8.26: Status reports in response to ATH
ATPC 1 <cr> Activates the PC Dial mode
ATPC0 <cr> Deactivates the PC Dial mode
ATD nnn...<cr> Writes nnn... on the terminal display
ATDT nnn...<cr> Equivalent to ATD
ATDP nnn...<cr> Equivalent to ATD
ATD@ 351 <cr> Seizes and dials the number 351
ATD/|*21205 PX/<cr> Seizes internally and initiates a Call Forwarding Unconditional
CALL V FROM nnnn <cr> The PC Dial application displays a call with
CALL V FROM name/nnn <cr> one of the following messages,
CALL V FROM name/<cr> depending on whether name or number
CALL V FROM <cr> information is available.
ATA <cr> Answers call with hands-free mode
ATH <cr> Terminates call connection (goes on-hook)
ATE1 <cr> Activates echo
ATEO <cr> Deactivates echo
ATH? Enquires about connection status
IDLE <cr> The terminal is idle (free)
DIALLING <cr> The terminal is sending dialling pulses
CONNECT <cr> The connection is set up
RING <cr> The terminal is being called
CALLING <cr> The terminal is receiving the ring-back tone
TRANSPARENT MODE <cr> The terminal is sending voice-frequency signals
To Next Page
Loading...
