Ascotel IntelliGate 2025/2045/2065
38 Safety and Commissioning
Before Commissioning
Check for completeness when unpacking the delivered system. Complaints are to
be settled within an appropriate period.
Damaged Components
Check the components for damage. Damaged systems or components must not
be put into operation.
Foreign Matter in the Hardware
If objects or liquids have penetrated the equipment and/or modules, said equip-
ment and/or modules must not be put into operation.
Hazard:
There is a risk of electrical shock or short-circuits if the hardware is dam-
aged in any way or if liquids or objects get inside the equipment.
Immediately disconnect the system from the power supply (230 V mains
as well as UPS and DC power supply if present).
Electrostatic Discharge
Warning:
The system's reliability can be adversely affected by electrostatic dis-
charges caused by touching electronic components and elements, and
subsequent damage can result. Always observe the ESD guidelines.
Mounting Instructions
Observe the following stipulations when installing the system:
• Do not expose the system to direct sunlight or other sources of heat (radiators).
Observe the guaranteed temperature range.
• Observe the minimum distances specified in the assembly guidelines.
• To ensure the necessary circulation of air, do not obstruct the system's cooling
ducts.
• The premises in which the system is installed must meet the following require-
ments:
– Protected against water, condensation and humidity
– Well ventilated
– Observance of the permitted humidity range
haz0001aaxxa0
To Next Page
Loading...
