Ascotel IntelliGate 2025/2045/2065
562 Features Part 2
Other properties:
• The configuration is set for each subscriber and can only be made via AIMS.
• The function can be stored on any configurable keys of the Office terminals.
• Several keys on each terminal can be configured as Redkeys.
• The Redkey function is triggered by a single, double or long-click of the corre-
sponding key.
• Once a Redkey has been configured, it can only be reconfigured via AIMS.
• The application on the ATAS server can acknowledge that a function has been
triggered by a Redkey by sending a message to the terminal’s display (with or
without a prompt to acknowledge the message).
Hotkey modes on DECT system terminals
On DECT system terminals the Redkey function can be configured on the Hotkey.
To ensure that again only one keystroke is needed to trigger the function, the
Hotkey can be limited to one storage location (instead of 6) by using the param-
eter "1 Hotkey only = Yes" in the subscriber settings. In this mode the Hotkey is
triggered even if the keypad lock is activated (requires a long click). This setting
can be configured with AIMS for each DECT terminal.
8.8.5 Interface descriptions
The ATAS and ATPC1 protocols can be disclosed to interested manufacturers of
messaging, monitoring and alarm equipment on request. Contact Support or go
directly to "open.interfaces@aastra.com".
8.9 Handset as visitor
An Ascotel DECT subscriber can be logged on via AIMS or the System Assistant
for the duration of a visit (see "Ascotel DECT configuration", page 857).
One hour before the visiting time expires, the system sends the message "<DECT
SC No.> will be logged off in one hour" to a configurable internal subscriber.
When the visiting time expires, the handset is automatically logged off from the
system.
To Next Page
Loading...
