Ascotel IntelliGate 2025/2045/2065
Part 3 Planning DECT systems 659
Once the coverage range of the two radio units has been measured out, the radio
units are repositioned. It may also make sense to measure out only part of the sup-
ply range and then to shift only one of the two radio units.
Please note
• Make sure the test handset is logged on / re-registered with the correct radio
unit.
• Make sure there is only one test handset in the critical area.
Tip:
To increase efficiency, 2 people can measure simultaneously with the 2
standard handsets. In this case the test handsets are used for communi-
cating with each other.
If you are unsure which value belongs to which radio unit, you can
retrieve the information using the "i" key. The top line then displays the
identification of the radio unit marked with "<". Press "i" a second time
to display all 4 radio units once again.
To Next Page
Loading...
