Aastra Ascotel IntelliGate 2065 - 6.2.1 Creating the routes; 6.2.1.1 Replicating the systems on routes

Ascotel IntelliGate 2025/2045/2065
682 Planning a private network Part 3
4. Create the numbering plan (as of page 688).
5. Set up direct dialling in (as of page 696).
Fig. 3.69: The specimen network
6.2.1 Creating the routes
6.2.1.1 Replicating the systems on routes
A route always defines a destination. A destination is either a system in the net-
work or a connection to the public network. You need to create as many routes
as there are destinations. To ensure a clearer overview, the same route in each sys-
tem is always used for the same destination, i.e. a route is reserved for each des-
tination.
Port: T
2
Trunk
group 1-1
Port: T
2
Trunk
group 1-5
Port: T
2
Trunk
group 3-4
Port: external S
Trunk group 1-4
Trunk group 2-4
Port: T
haz0812aaena0
PINX 1
(destination
of route 5)
PINX 3
(destination
of route 7)
PINX 2
(destination
of route 6)