Ascotel IntelliGate 2025/2045/2065
690 Planning a private network Part 3
1. Create the internal subscribers:
– System 1: Internal subscribers 200 to 299
– System 2: Internal subscribers 300 to 399
– System 3: Internal subscribers 400 to 499
2. Specify the regional prefix:
– In System 1: Own region prefix = 60
– In System 2: Own region prefix = 60
– In System 3: Own region prefix = 60
With this method local area network (see page 682) is not used. The number
ranges of the other systems have to be defined. To do so create numbers in the
PISN subscribers category in the numbering plan. There you can create either indi-
vidual numbers or number ranges by specifying the range with "XX". Each "X"
corresponds to one digit place.
1. Create the PISN subscribers in system 1:
– One PISN subscriber 3XX (range of system 2)
– One PISN subscriber 4XX (range of system 3)
2. Create the PISN subscribers in system 2:
– One PISN subscriber 2XX (range of system 1)
– One PISN subscriber 4XX (range of system 3)
3. Create the PISN subscribers in system 3:
– One PISN subscriber 2XX (range of system 1)
– One PISN subscriber 3XX (range of system 2)
Under the subscriber configuration you will find the PISN subscribers you have just
created, with the numbers 2XX, 3XX and 4XX.
The setting options for PISN subscribers differ from those of ordinary internal sub-
scribers. Next use the "route" setting to allocate routes to the PISN subscribers:
1. Assign the routes for the PISN subscribers of system 1:
– PISN subscriber 3XX: Route 6
– PISN subscriber 4XX: route 7
2. Assign the routes for the PISN subscribers of system 2:
– PISN subscriber 2XX: Route 5
– PISN subscriber 4XX: route 7
3. Assign the routes for the PISN subscribers of system 3:
– PISN subscriber 2XX: Route 5
– PISN subscriber 3XX: route 6
To Next Page
Loading...
