Aastra Ascotel IntelliGate 2065 - 7.5.1.1 V.24 interface on the mainboard; 7.5.1.2 V.24 interface on the Pocket Adapter (PA)

Ascotel IntelliGate 2025/2045/2065
790 Cabling interfaces Part 4
7.5.1.1 V.24 interface on the mainboard
Connection
= Pin 1
Fig. 4.65: V.24 interfaces on the 2025 / 2045 and 2065 mainboards
Settings
The port address of V.24 interfaces on the mainboard is 0.1 and 0.2.
See also:
For details of the settings see AIMS, Configuration Manager, Call Log-
ging and Event Messages
Signalling the Ready Status
The PBX uses the DTR signal (Data Terminal Ready) to indicate that the V.24 inter-
face status is ready.
7.5.1.2 V.24 interface on the Pocket Adapter (PA)
The PA provides a V.24 interface for connecting an AD2 interface with a PC. The
PA's V.24 cable is connected to a serial interface on the PC
1)
.
Two terminals can be connected to an AD2 interface. An Office terminal can be
connected via the PA. The PBX differentiates the two terminals on the basis of the
position of DIP switch S2 on the PA (see Fig. 4.67) and the setting of the terminal
selection digit (TSD) on the Office terminal. Both terminals must have a different
TSD.
1)
PA Version ≥ V2.4
0.1 0.2
V.24
Com 1
Com 2
haz1141aaxxb0