Aastra Ascotel IntelliGate 2065 - 8.1.2 Office25, Office35, Office45

Ascotel IntelliGate 2025/2045/2065
Part 4 Installing terminals 819
Fig. 4.81: Set the AD2 bus address
Note:
Make sure the TSD (address switch) is pushed in as far as the stop or the
switchover will not function correctly.
If the LED flashes slowly, the wrong terminal type is configured.
8.1.2 Office 25, Office 35, Office 45
Installation
1. Set the AD2 bus address under the terminal's designation label.
– TSD1 = Address switch not pressed (disengaged)
– TSD2 = Address switch pressed (engaged)
2. Plug the coiled cable into the underside of the Office.
3. Feed the coiled cable through the strain relief.
4. Plug the coiled cable into the handset.
5. Plug the connecting cable to the terminal and feed it through the strain relief.
6. Plug the connecting cable into the socket.
7. If the system is configured, test the operation of the terminal.
8. Label the telephone.
TSD2
TSD1
haz1045aaena0