Ascotel IntelliGate 2025/2045/2065
Part 5 Configuration Steps 855
Each licence code can only be used for one PBX. To licence several systems, you
will obtain separate licence codes to match the licence information of the individ-
ual systems.
The licence information can be viewed directly from the PBX using the Configu-
ration Manager in AIMS ("Licensing" menu item in the basic setup of the system
configuration).
5.3 PBX / PINX configuration
Preparing the system
1. Initialize the system. All the data is deleted and the initialization values are set.
(see "System initialization", page 853).
2. Log into the configuration (see "Configuration with AIMS", page 843).
Numbering plan and subscribers
3. Define the numbering plan and subscribers (see "The System's Numbering
Plan", page 163).
– The DDI numbers supplied by the network operator are important for the
choice of subscriber numbers.
– Configure the PISN subscribers.
– Define the DECT subscribers.
– Define the pager subscribers.
If you delete numbers already configured in the numbering plan, those num-
bers will also be removed from the user groups, busy display variants,
announcement groups, call distribution elements.
4. Define the subscriber settings: Name, authorizations, etc.
Call distribution and direct dialling
5. Define the user groups (see "User Group", page 236).
– Subscriber
– Call distribution type
– Operator Console element if required
– General bell element if required
– Set the delays
To Next Page
Loading...
