Ascotel IntelliGate 2025/2045/2065
Part 7 Hardware updates and system expansion 907
3.2.1.3 New card with fewer ports
A card is replaced by a similar card with fewer ports.
Procedure:
1. Change the card and put the PBX into operation again (see "Replacing a
defective card", page 906).
The following data is deleted:
• The system and terminal configuration data of the terminals on the user-net-
work interfaces that are no longer present in the new configuration.
• The system configuration data of the network interfaces that are no longer
present in the new configuration.
Tab. 7.4: Example: Reducing the number of user-network interfaces
Note:
If the terminal configuration data of system terminals is deleted follow-
ing the reconfiguration of an expansion card, a warning message will
appear beforehand to give you the possibility of cancelling the process.
However, this is possible only if the configuration data of the original
card was not already deleted beforehand.
3.2.1.4 New card with more ports
A card is replaced by a similar card with more ports.
Procedure:
1. Change the card and put the PBX into operation again (see "Replacing a
defective card", page 906).
2. Select “Accept System Configuration” in the AIMS Configuration Manager.
3. Configure new ports.
The system configuration data (SC No., SC configuration, etc.) of the terminals on
the new ports is created as new data (initialization values).
SC-16AD2 → SC-08AD2 The configuration data of user-network interfaces 9...16 is deleted.
SC-08AD2 → ISDN-04ST The configuration data of all 8 user-network interfaces is deleted.
To Next Page
Loading...
