System Functions and Features as of I7.9
Call routing 229
syd-0200/3.0 – I7.9 – 11.2009
Settings on the source PINX (PINX 1):
• User configuration:
A permanent CLIP number is configured for internal users in Geneva, which is
transmitted unchanged along with each outgoing call to the public network.
• Least Cost Routing:
The initial digits of the numbers within the Zurich local rate zone are entered in
the LCR table and allocated a route via the routing and network operator table
(see also "Least Cost Routing (LCR)", page 181).
• Setting up routes:
– All calls sent to the public network via Zurich are routed via a separate route.
Its configuration must
NPI = E.164 must be set so that PINX 2 recognises a call as external and routes
it accordingly.
– All calls addressed to PINX 2 users in Zurich are routed via another route
whose configuration contains the setting NPI = PNP.
– Both routes can be allocated to the same trunk group.
• Trunk group settings:
– Network = private
– Protocol = PSS1
– Automatic CLIP = Ye s
Tab. 80 Settings for break-out routing at the source PINX
(PINX 1 in Geneva)
Parameter Parameter value
User configuration:
• Automatic CLIP No (permanently CLIP number entry is used)
• NPI E.164
• TON National
• CLIP number 022 827 9x xx
(x stands for the user’s DD number)
LCR table:
• ... ...
• 01 810 Zurich (allocate to the "Zurich" routing table)
• 01 811 Zurich (allocate to the "Zurich" routing table)
• 01 813 Zurich (allocate to the "Zurich" routing table)
• ... ...
"Zurich" routing table:
• Time zone x•Network provider: BreakOutZH
• Times: Allocate the times for "BreakOutZH"
To Next Page
Loading...
