System Functions and Features as of I7.9
230 Call routing
syd-0200/3.0 – I7.9 – 11.2009
Settings at the gateway PINX (PINX 2)
Specifying the transit route
The transit route is specified using the Transit route setting. If an incoming call has a
phone number with numbering plan identifier NPI = E.164, it will be forwarded via
the defined route. This route leads to the public network (see also page 217).
Tab. 81 Settings for the break-out routing at the gateway PINX
(PINX 2 in Zurich)
Network operator table:
• Network provider "BreakOutZH" Route 5
• Conversion rule N (add dialled phone number)
Route 5:
• Name Zurich, ISDN exchange
• Trunk groups 2
• Digit barring No (do not consult digit barring)
• Outgoing connections Number of connections allowed simultaneously
• Numbering plan identifier NPI E.164
• Type of number TON Unknown
Trunk group 2:
• Name Zurich, PINX 2
• Network interfaces Network interfaces of this trunk group
• Network type Private
• Protocol QSIG or QSIG / PSS1 ISO
• Automatic CLIP yes
Parameter Parameter value
Transit route:
• Route 4 (this route is used for the transit routing)
Route 4:
• Name Zurich, exchange
• Trunk groups 1
• Numbering plan identifier NPI E.164
• Type of number TON Unknown
Trunk group 1:
• Name Zurich, ISDN exchange
• Network interfaces Network interfaces of this trunk group
• Network type Public
• Protocol DSS1
• Automatic CLIP yes
Parameter Parameter value
To Next Page
Loading...
