Be sure that the IED object in PCM600 has the same IP address as the
physical IED, which is intended to be connected through the technical
key concept.
The technical key for an IED object in PCM600 can also be changed
in the Object properties window.
1. Select the IED in the Plant Structure.
2. Right-click and select Set Technical Key, see Figure 6.
IEC09000667 V3 EN
Figure 6: PCM600: Set technical key menu at IED level
A dialog window opens to inform about the technical key concept.
3. Click OK in the dialog window.
The technical key is read from the IED and the technical key editor window
opens, see
Figure 7.
1MRK 511 284-UEN A Section 4
Setting up a project
650 series 25
Engineering manual
To Next Page
Loading...
