IEC13000060 V1 EN
Figure 12: Select the TCP/IPv4 protocol and open Properties
5. Select Obtain an IP address automatically if the parameter DHCPServer is set
to On in the IED.
IEC13000061 V1 EN
Figure 13: Select: Obtain an IP address automatically
6. Select Use the following IP address and define IP address and Subnet mask if
the front port is used and if the IP address is not set to be obtained automatically
Section 4 1MRK 511 284-UEN A
Setting up a project
30 650 series
Engineering manual
To Next Page
Loading...
