Maintaining Archive Media Section 7 Configuring Archives
114 2PAA107563-600 B
set to Advance When Full or Wrap When Full. For manual archives, the volume
must be manually initialized.
Initialization of archive volumes may be done using the archive device aspect for the
archive device whose volume needs to be initialized, or the archive volume aspect
may be used.
To initialize a volume:
1. Install the archive media in the disk drive.
2. Navigate to and select either the archive device aspect whose volume is being
ini
tialized, or select the applicable archive volume aspect.
3. If the archive volume aspect is being used, i
nvoke the Initialize command from
the Action button or context menu as shown in Figure 68, then skip steps 4 and
5 which pertain only when using the archi
ve device aspect. Resume the
procedure at Step 6.
Figure 68. Initializing a Volume From the Archive Volume Aspect
For MO drives, before the archive volume is initialized, make sure the media has
been formatted as described in Removing/Replacing Platters on page 110 .
To Next Page
Loading...
