ABB 800xA - Copy Volume Dialog; Copy Volume Specification

Maintaining Archive Media Section 7 Configuring Archives
118 2PAA107563-600 B
This displays the Copy Volume dialog, Figure 72. Use this dialog to specify the
copy volume parameters as described in Table 16. Click OK when done.
Figure 72. Copy Volume Dialog
Table 16. Copy Volume Specification
Field Description
Source Volume ID Automatically filled in based on the volume whose aspect is
selected.
Destination Volume ID Enter the Volume ID for the new copy. This is typically the same as
the Source Volume ID.
Destination Path Enter the full path to the location (drive\folder\folder...) where the
copy will be created.
Destination Volume
Label
Used to specify a new volume label. The default is to use the label
of the volume being copied.
Overwrite Timeout Used to specify a new overwrite timeout. The default is to use the
overwrite timeout of the volume being copied.
Include Archives Used to specify the range of archive entries to copy.