Start/Stop History Embedded Data Collector Database Section 5 Maintenance and Administration
58 2PAA107563-600 B
3. Double-click the Stop RTDB batch file and type ‘Y’ in the confirmation
prompt as shown in Figure 33 to stop the main real time database service in
History Embedded Data Collector Node.
Figure 33. Confirmation Prompt for stopping RTDB
Once the Database stopping process is completed, the system displays the message
“RTDB-service has now been stopped. All tables are OK”.
Start/Stop History Embedded Data Collector Database
To stop the 800xA History Embedded Data Collector database perform one of the
following methods:
1. Start/Stop the database from the database control
panel.
– To start the database, refer Starting Database using RTDB Control Panel.
– To stop the database, refer Stopping Database using RTDB Control Panel.
2. Start/Stop Database from ABB System 800xA Service Structure.
– To start the database from 800xA Service St
ructure, refer Starting
Database from ABB System 800xA.
– To stop the database from 800xA Service Structure, refer Stopping
Database From ABB System 800xA.
To Next Page
Loading...
