____________________________________________________________________________________________________________
G1 Introduction to AC500 1-128 AC500 / Issued: 07.2006
Now append a slave to the PROFIBUS DP line. Click below the master surrounded by a frame. A
rectangle indicates the area where the slave will be inserted.
Select
Insert -> Slave from the menu bar.
The mouse pointer changes to an arrow with an 'S'. Proceed as already described for the master in
order to place the slave. A new window appears.
Left click with the mouse on that position on the screen where you want to place the Slave. Another
window appears. Scroll down in the left-hand area and select
PDP22-FBP (DPV1 modular) as the
slave. Then click on
ADD >>
.
Your selection is displayed on the right-hand side of the window.
In this window, you can also change the default station address and enter a description for the device.
Then click on
OK.
To Next Page
Loading...
