ABB AC500 - Page 131

____________________________________________________________________________________________________________
G1 Introduction to AC500 1-129 AC500 / Issued: 07.2006
The configured fieldbus is displayed.
Double click inside of the rectangle surrounding the slave in order to configure the slave. A new window
named
Slave Configuration appears.
The modular station has to be configured in order to specify the used hardware. First, select the FBP
interface module
DC505-FBP (list of available modules ('Module' column) in the window shown above;
the selected module is highlighted by a rectangle). Click on
Append Module to insert it into the list of
configured modules.