____________________________________________________________________________________________________________
G1 Introduction to AC500 1-130 AC500 / Issued: 07.2006
The following information is given for the selected modules: Slot number (Slot), module type (Module)
and definition of the input bytes/words IB/IW and the output bytes/words QB/QW. Then we have to
specify the expansion modules of the used hardware. In our example this is a digital input/output module
DC532 and an analog input/output module AX522.
After you have added all required modules into the configuration list, click on
OK to apply the
configuration.
Call the address table before you specify the parameter data (via
View -> Address Table) in order to
update the addresses of the input/output variables.
If you want to change the device parameters of the slave, select the device entry to highlight it by a
rectangle. Press the right mouse button and select
Parameter Data from the context menu.
To Next Page
Loading...
