For more information on the BAPO-01 module, see BAPO-01 auxiliary power extension
module (page 199).
RC
RA
RB
+24V DGND DCOM SGND S+
DI1
DI2
S1
S2
Connecting a PC
You can connect a PC to the drive. To communicate with the drive, the PC must have
suitable software (for example, Drive composer) installed.
If you have an assistant control panel (ACH-AP-H or ACH-AP-W), use a USB data cable
(Type A - Type Mini-B, maximum length 3 m [9.8 ft]) to connect to the PC. Connect the
cable as follows:
1. Open the USB connector cover on the control panel.
2. Connect the USB cable Mini-B plug to the control panel USB connector.
3. Connect the USB cable A plug to the USB port of the PC. The panel shows text
“USB connected”.
Note: You cannot use the control panel keys when the drive is connected to a PC.
If you have a RDUM-01 blank panel or CDPI-02 panel bus adapter installed, use a
BCBL-01 USB-RJ45 converter to connect to the PC.
It is also possible to use a CCA-01 configuration adapter when the drive is not connected
to the power supply network or to an external 24 V supply. The CCA-01 does not operate
if the drive is powered.
Installing options
The drive has two option module slots:
• Front option: Communication module slot under the front cover.
• Side option: Multifunction extension module slot on the side of the drive.
Refer also to the fieldbus module manual for the installation instructions. For other option
modules, see:
•
BAPO-01 auxiliary power extension module (page 199)
•
BIO-01 I/O extension module (page 203)
•
BREL-01 relay output extension module (page 207).
82 Electrical installation – IEC
To Next Page
Loading...
