ACH550-UH User’s Manual 1-167
Parameters
5309 EFB STATUS 0…7 1 0 (IDLE)
Contains the status of the EFB protocol.
0 = IDLE – EFB protocol is configured, but not receiving any messages.
1 =
EXECUT INIT – EFB protocol is initializing.
2 =
TIME OUT – A timeout has occurred in the communication between the network master and the EFB protocol.
3 =
CONFIG ERROR – EFB protocol has a configuration error.
4 =
OFF-LINE – EFB protocol is receiving messages that are NOT addressed to this drive.
5 =
ON-LINE – EFB protocol is receiving messages that are addressed to this drive.
6 =
RESET – EFB protocol is performing a hardware reset.
7 =
LISTEN ONLY – EFB protocol is in listen-only mode.
5310 EFB PAR 10 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40005.
5311 EFB PAR 11 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40006.
5312 EFB PAR 12 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40007.
5313 EFB PAR 13 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40008.
5314 EFB PAR 14 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40009.
5315 EFB PAR 15 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40010.
5316 EFB PAR 16 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40011.
5317 EFB PAR 17 0…65535 1 0
Specifies the parameter mapped to Modbus Register 40012.
5318 EFB PAR 18 0…65535 1 0
For Modbus: Sets additional delay in milliseconds before the ACH550 begins transmitting response to the master
request.
5319 EFB PAR 19 0000…FFFF hex 1 0000 hex
ABB Drives profile (
ABB DRV LIM or ABB DRV FULL) Control Word. Read only copy of the Fieldbus Control Word.
5320 EFB PAR 20 0000…FFFF hex 1 0000 hex
ABB Drives profile (
ABB DRV LIM or ABB DRV FULL) Status Word. Read only copy of the Fieldbus Status Word.
Group 53: EFB Protocol
Code Description Range Resolution Default S
To Next Page
Loading...
