3-14 ACH550-PCR/PDR User’s Manual
Installation
Install the line input wiring
Line input connections – standard drive with input disconnect configurations
Connect input power to the terminals of the disconnect switch or circuit breaker.
Connect the equipment grounding conductor to the ground lug at the top of the
enclosure. The figure below shows the connection points for Standard Drive with
Input Disconnect configurations.
Note: The terminals on disconnect switches for the following rated ACH550-PDR
products is 7 in-lbs. Do not use a power driver or over tighten to prevent breaking
screw heads or stripping the terminal.
230 VAC 460 VAC 600 VAC
-04A6-2 -03A3-4 -02A7-6
-06A6-2 -04A1-4 -03A9-6
-07A5-2 -06A9-4 -06A1-6
-012A-2 -08A8-4 -09A0-6
-017A-2 -012A-4 -011A-6
-024A-2 -015A-4 -017A-6
-031A-2 -023A-4
Input
Power
Input
Power
UL Type / NEMA 1 & 12 UL Type / NEMA 1 & 12
Enclosures Enclosures
UL Type / NEMA 1 & 12
Enclosures
Dashed line is ground run.
Vertical Construction Hinged Door Wall Mount
Floor Mount
ACH550
Input Power
Terminals
Motor
Terminals
Ground Lug
Bar
Disconnect Switch
or Circuit Breaker
To Next Page
Loading...
