Frames R6…R9
R6 IP21 / UL Type 1
The layout of a frame R6 drive is presented below. The constructions of frames R6…R9
differ to some extent.
1
5
2
4
3
5
6
7
8
9
10
9
13
14
20
18
15
12
12
16
11
1
19
14b
5
PE
17
Varistor grounding screw (VAR), under the
control panel platform. For disconnecting,
see page 120 (IEC) or page 170 (North
America).
13
Two EMC filter grounding screws, 14a:
EMC (DC) under the control panel platform
and 14b: (EMC (AC) at the left, above the
shroud. For disconnecting, see page 120
(IEC) or page 170 (North America).
14
Shroud. Under the shroud: Input power
connection (L1, L2, L3), motor connection
(T1/U, T2/V, T3/W) and DC connection
(UDC+, UDC-)
15
PE connection (power line)16
Grounding connection (motor), under the
shroud (15)
17
Cable entry18
Main cooling fan19
Auxiliary cooling fan20
Mounting points (6 pieces: 2 at the top, 2
at the bottom of the main part of the frame,
2 at the top of the cable box)
1
Cover2
Cable/conduit box3
Heatsink4
Lifting holes (6 pieces)5
Control panel6
Control panel connection7
Cold configuration connection for CCA-018
Power OK and Fault LEDs. See section
LEDs (page 227).
9
I/O connections. See External control
connection terminals, frames
R1…R5 (page 45).
10
Cable tie mounts for /I/O cables11
Clamps for I/O cable mechanical support12
Operation principle and hardware description 43
To Next Page
Loading...
