ABB ACH580-01 - Page 7

92
Additional requirements for ABB motors of types other than M2_,
M3_, M4_, HX_ and AM_ .................................................................
92Additional requirements for braking applications ..............................
92
Additional requirements for the regenerative and low harmonics
drives ................................................................................................
92Additional requirements for ABB high-output and IP23 motors ........
93Additional requirements for non-ABB high-output and IP23 motors ..
94
Additional data for calculating the rise time and the peak line-to-line
voltage ..............................................................................................
95Additional note for sine filters ...........................................................
96Selecting the power cables .................................................................................
96General guidelines .......................................................................................
96Typical power cable sizes ............................................................................
96Power cable types ........................................................................................
96Preferred power cable types .............................................................
97Alternate power cable types .............................................................
98Not allowed power cable types .........................................................
99Additional guidelines, North America ...........................................................
99Metal conduit ....................................................................................
100Power cable shield .......................................................................................
100Grounding requirements .....................................................................................
101Additional grounding requirements – IEC ....................................................
102Additional grounding requirements – UL (NEC) ...........................................
102Selecting the control cables ................................................................................
102Shielding ......................................................................................................
102Signals in separate cables ...........................................................................
102Signals that can be run in the same cable ...................................................
103Relay cable ..................................................................................................
103Control panel to drive cable .........................................................................
103PC tool cable ................................................................................................
103FPBA-01 PROFIBUS DP adapter module connectors ................................
103Routing the cables ..............................................................................................
103General guidelines – IEC .............................................................................
104General guidelines – North America ............................................................
105
Continuous motor cable shield/conduit or enclosure for equipment on the
motor cable ..................................................................................................
106Separate control cable ducts .......................................................................
106Implementing short-circuit and thermal overload protection ...............................
106Protecting the drive and the input power cable in short-circuits ...................
107Protecting the motor and motor cable in short-circuits .................................
107Protecting the motor cables against thermal overload .................................
107Protecting the motor against thermal overload ............................................
107
Protecting the motor against overload without thermal model or temperature
sensors .........................................................................................................
Table of contents 7