ABB ACH580 Series - Page 134

ACH580 E-Clipse bypass and packaged drive user manual 125
Embedded fieldbus
Note: For Present Value Access Types, R = Read-only, W = Writeable,
C = Commandable. Commandable values support priority arrays and relinquish
defaults.
Binary value object instance summary – Drive
The following table summarizes the Binary Value Objects supported:
BO4 RO5 CMD This object controls the output state of
Relay 1. This control requires that drive
parameter 15.10 value = 62 (RO/DIO
control word). Also requires CMOD-01
option.
ON/OFF C
BO5 RO6 CMD This object controls the output state of
Digital Output 1. This control requires
that drive parameter 15.23 value = 62
(RO/DIO control word). Also requires
CMOD-01 option.
ON/OFF C
Instance
ID
Object Name Description
Active/Inactive
Text
Present Value
Access Type
BV0 RUN/STOP ACT This object indicates the drive
Run Status, regardless of the
control source.
RUN/STOP R
BV1 FWD/REV ACT This object indicates the
motor’s rotation direction,
regardless of the control
source.
REV/FWD R
BV2 FAULT ACT this object indicates the drive’s
fault status.
FAULT/OK R
BV3 EXT 1/2 ACT This object indicates which
control source is active:
External 1 or External 2.
EXT2/EXT1 R
BV4 HAND/AUTO ACT This object indicates whether
the drive is under Hand or Auto
control.
HAND/AUTO R
BV5 WARNING ACT This object indicates the drive’s
warning status.
WARNING/OK R
BV7 DRIVE READY This object indicates whether
the drive is ready to accept a
run command.
READY/NOT
READY
R
BV8 AT SETPOINT This object indicates whether
the drive is at the commanded
setpoint.
YES/NO R
BV9 ENABLE ACT
This object indicates the System
Enable command status (the
combination of all Run and Start
Interlocks), regardless of the
control source.
ENABLE/
DISABLE
R
Instance
ID
Object Name Description
Active/
Inactive Text
Present Value
Access Type