ABB ACQ580-31 - Page 5

5
 Connection procedure with VFD cable
For connection procedure with conduits, see Connection procedure with conduit .
1. Attach a residual voltage warning sticker in the local language.
2. Frames R6 and R8:
Remove the shroud on the power cable terminals.
Frame R8:
For easier installation, you can remove the side plates.
3. Prepare the power cables:
• Remove the rubber grommets of the cables to be installed from the cable entry plate. Remove the unused grommets
and reinstall with the cone pointing down (3a).
• Cut a sufficient hole in the rubber grommet. Slide the grommet onto the cable (3b) with the remaining cone pointing
down.
• Prepare the ends of the input power cable and motor cable as illustrated in the applicable figure (3c).
• Slide the cables through the holes in the cable entry and attach the grommets to the holes.
4. Connect the power cables. For the tightening torques, refer to
Terminal data.
• Ground the shield 360 degrees by tightening the clamp of the power cable grounding shelf onto the stripped part of
the cable (4a).
• Connect the twisted shield of the cable shields to the grounding terminals (4b).
• Frame R8: to install the common mode filter, see Related documents .
• Connect the phase conductors of the motor cable to the T1/U, T2/V and T3/W terminals. Connect the phase
conductors of the input power cable to the L1, L2 and L3 terminals (4c).
• Tighten the screws to the torque given in the installation drawing below.
R6
R8
R8R8
R6
3b
3c
PE
PE
3a
L1
L2
L3
UDC+
UDC-
T1/U
T2/V
T3/W
4b
4c
1.7 N·m
4a
1.7 N·m
1.7 N·m
1.7 N·m
L1, L2, L3, T1/U, T2/V, T3/W: 1.7 N·m (15 l bf·in)
R3
(15 l bf·in)