ABB ACQ810 - Page 157

Parameters 157
14.62 Freq out max src When 14.06 DIO2 conf is set to Freq output, defines the real
value of the signal (selected by parameter 14.61 Freq out
src) that corresponds to the maximum DIO2
frequency output value (defined by parameter 14.64 Freq
out max sca).
0 … 32768 Real signal value corresponding to maximum DIO2 output
frequency.
1 = 1
14.63 Freq out min src When 14.06 DIO2 conf is set to Freq output, defines the real
value of the signal (selected by parameter 14.61 Freq out
src) that corresponds to the minimum DIO2 frequency output
value (defined by parameter 14.65 Freq out min sca).
0 … 32768 Real signal value corresponding to minimum DIO2 output
frequency.
1 = 1
14.64 Freq out max sca When 14.06 DIO2 conf is set to Freq output, defines the
maximum DIO2 output frequency.
3 … 32768 Hz Maximum DIO2 output frequency. 1 = 1 Hz
14.65 Freq out min sca When 14.06 DIO2 conf is set to Freq output, defines the
minimum DIO2 output frequency.
3 … 32768 Hz Minimum DIO2 output frequency. 1 = 1 Hz
14.66 RO6 src Selects a drive signal to be connected to relay output RO6.
Trad pump6 Bit 5 of 05.02 Trad pump cmd (see page 125). 1074070786
Ready Bit 0 of 06.01 Status word1 (see page 126). 1073743361
Enabled Bit 1 of 06.01 Status word1 (see page 126). 1073808897
Started Bit 2 of 06.01 Status word1 (see page 126). 1073874433
No. Name/Value Description FbEq
f
DIO2
(Hz)
14.64
14.65
14.62 14.63
14.6214.63
14.64
14.65
Signal (real)
selected by
par. 14.61
f
DIO2
(Hz)
Signal (real)
selected by
par. 14.61