ABB ACQ810 - Assistants

32 The ACQ810 control panel
 Assistants
Assistants are routines that guide you through the essential parameter settings
related to a specific task, for example application macro selection, entering the motor
data, or reference selection.
An assistant may merely consist of a sequence of parameters that the user must
adjust, but may also involve questions; based on the answers, one or several
parameters are automatically adjusted. The assistant may also display additional
information about the selections.
In the Assistants mode, you can:
• use assistants to guide you through the specification of a set of basic parameters
• start, stop, change the direction and switch between local and remote control.
Different firmware versions may include different assistants.
How to invoke an assistant
The table below shows how assistants are invoked.
Step Action Display
1. Go to the Main menu by pressing if you are in the
Output mode.
Otherwise press repeatedly until you get to the
Main menu.
2. Go to the Assistants mode by selecting ASSISTANTS on
the menu with keys and , and pressing
.
3. Select an assistant by highlighting it with and
, and by pressing .
• Whenever the assistant prompts the user to adjust a
parameter, the adjustment is made as described
starting on page 25.
• Whenever the assistant prompts a question, select the
most suitable answer with and , and
press .
4. After the assistant has been completed, the main menu is
displayed. To run another assistant, repeat the procedure
from step 2.
To abort the assistant at any point, press .
MENU
EXIT
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT ENTER
00:00
MAIN MENU 1LOC
ENTER
Select assistant:
Motor Set-up
Application Macro
Start-up assistant
EXIT
OK
00:00
CHOICE
LOC
1/3
OK
OK
9904 Motor type
PAR EDIT
AM
EXIT SAVE00:00
[0]
LOC
EXIT