EasyManua.ls Logo

ABB ACQ810 - Page 326

ABB ACQ810
376 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
326 Fault tracing
0070 TEMP MEAS FAILURE
(0x4211)
Problem with internal
temperature measurement
of the drive.
Contact your local ABB representative.
0071 EFB COMM LOSS
(0x7540)
Embedded fieldbus
interface has been taken
into use, and there is a
communication break
between the drive and the
master station.
Check:
selection of the parameter which
enables/disables EFB communication
(58.01 Protocol ena sel)
EFB connection at terminal XD2D on
the JCON board
status of the fieldbus master (online/
offline)
settings of the communication
supervision function (parameter 58.09
Comm loss action).
0201 T2 OVERLOAD
(0x0201)
Firmware time level 2
overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0202 T3 OVERLOAD
(0x6100)
Firmware time level 3
overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0203 T4 OVERLOAD
(0x6100)
Firmware time level 4
overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0204 T5 OVERLOAD
(0x6100)
Firmware time level 5
overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0205 A1 OVERLOAD
(0x6100)
Application time level 1 fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0206 A2 OVERLOAD
(0x6100)
Application time level 2 fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0207 A1 INIT FAULT
(0x6100)
Application task creation
fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0208 A2 INIT FAULT
(0x6100)
Application task creation
fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0209 STACK ERROR
(0x6100)
Drive internal fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0210 FPGA ERROR
(0xFF61)
Drive internal fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0301 UFF FILE READ
(0x6300)
File read error
Note: This fault cannot be
reset.
Contact your local ABB representative.
Code
Fault (fieldbus code),
other information
Cause What to do

Table of Contents

Other manuals for ABB ACQ810

Related product manuals