ABB ACQ810 - Page 352

352 Control through the embedded fieldbus interface
ACT1 and ACT2 respectively. The table below clarifies the relation between the
value of drive parameter and fieldbus actual value (no scaling).
• If you select value Speed, the drive parameter 01.01 Motor speed rpm
will be
written to fieldbus actual value. The table below clarifies the relation between the
value of drive parameter value and the fieldbus actual value (no scaling).
Value of the selected drive signal Corresponding fieldbus actual value
ACT1 or ACT2 [integer and fractional
part]
32767.65535 32767.65535
00
-32768.65535 -32768.65535
Value of the selected drive signal Corresponding fieldbus actual value
ACT1 or ACT2 [integer and fractional
part]
32767.65535 32767.65535
00
-32768.65535 -32768.65535