The ACQ810 control panel 41
Parameter errors
If you try to backup and restore parameters between different firmware versions, the
panel shows you the following parameter error information:
Downloading continues, drive is being restarted.
The display shows the transfer status as a percentage of
completion.
Downloading finishes.
Step Action Display
1. Restore operation starts normally.
2. A version check is made.
You can see on the panel that the firmware versions are
not the same.
Scroll the text with keys and .
To continue, press . Press to stop the
operation.
Step Action Display
Restarting drive
PAR BACKUPLOC
00:00
PAR BACKUPLOC
5 0%
Restoring/downloading
all parameters
Finishing restore
operation
PAR BACKUPLOC
Initializing param.
restore operation
PAR BACKUP
LOC
00:00
FIRMWARE VERSION
UIFQ,200F,0,
UIFQ,200C,0,
OK
PRODUCT VARIANT
CANCEL CONT
VERSION CHECKLOC
1
00:00
FIRMWARE VERSION
PRODUCT VARIANT
7
7
OK
CANCEL CONT
VER CHECKLOC
2
00:00
To Next Page
Loading...
