ABB ACQ810 - Page 43

The ACQ810 control panel 43
Trying to restore a user set between different firmware versions
If you try to backup and restore a user set between different firmware versions, the
panel shows you the following alarm information:
5. You can edit parameters by pressing when EDIT
command is visible. Parameter 95.01 Ctrl boardSupply is
used as an example.
Edit the parameter as shown in section Parameters on
page 25.
6. Press to save the new value.
Press to return to the list of erroneous parameters.
7. The parameter value you chose is visible under the
parameter name.
Press when you have finished editing the
parameters.
Step Action Display
1. Restore operation starts normally.
2. Version check is also OK.
You can see on the panel that the firmware versions are
not the same.
You can scroll the text with keys and .
Step Action Display
EDIT
9501 Ctrl boardSupply
PAR EDIT
External 24V
CANCEL SAVE00:00
[1]
LOC
SAVE
CANCEL
9501 Ctrl boardSupply
PAR EDIT
Internal 24V
CANCEL SAVE00:00
[0]
LOC
READY
9501 Ctrl boardSupply
0
0
INCORRECT VALUE TYPE
9503
READY EDIT
PARAM ERRORSLOC
9
00:00
Initializing param
restore operation
PAR BACKUP
LOC
00:00
FIRMWARE VERSION
UIFQ,200F,0,
UIFQ,200C,0,
OK
PRODUCT VARIANT
CANCEL CONT
VER CHECKLOC
1
00:00
FIRMWARE VERSION
PRODUCT VARIANT
7
7
OK
CANCEL CONT
VER CHECKLOC
2
00:00