Application macros 87
Application macros
What this chapter contains
This chapter describes the intended use, operation, default control connections, start-
up procedure and an application example of each application macro.
More information on the connectivity of the JCU control unit is given in the Hardware
Manual of the drive.
General
Application macros are pre-defined parameter sets. When starting up the drive, the
user typically selects one of the macros as a basis, makes the essential changes and
saves the result as a user parameter set. User parameter sets are managed by the
parameters in group 16 System (page 164).
Application macros are activated through the control panel Main menu by selecting
ASSISTANTS – Application Macro. A few basic questions about the application
appear on the panel; based on the answers, the most suitable macro is applied by the
drive. Parameter 16.20 Macro selected indicates which application macro is active.
After the activation of an application macro, an assistant can optionally be launched
to set up the essential configuration parameters related to the application. Each of
these assistants can also be invoked later by selecting ASSISTANTS in the control
panel Main menu.
To Next Page
Loading...
